Electric Forklift Workflow Between Storage Racks

In modern warehouse operation scenarios, electric forklifts are widely used for goods transfer between dense storage racks for their low noise, zero local emission and stable performance features. A set of standardized operation workflow can effectively balance operation safety and goods turnover efficiency, and reduce unnecessary operation risks. Before entering the operation area, the operator needs to complete full pre-check work, which covers checking the remaining battery level, brake response performance, lifting mechanism status and warning light function of the electric forklift, confirm that the width of the aisle between two racks meets the passing requirement of the vehicle, clear up scattered obstacles on the aisle ground, and confirm the serial number of the target storage position, the total weight of the goods, to make sure the load is within the rated load range of the electric forklift. When driving into the narrow aisle between storage racks, the vehicle should keep a low and stable speed, keep full attention to avoid scratching the side of racks, stop the vehicle stably at the position 1 to 2 meters in front of the target position and pull the handbrake. During the goods access process, the operator needs to adjust the level and height of the forks slowly, align the forks with the insertion holes of the goods pallet, lift the forks to the designated height steadily, move the vehicle backwards at a constant speed to take the goods out from the rack, or push the pallet to the target layer of the rack when placing goods, confirm that the goods are placed firmly without exceeding the edge of the rack before pulling back the forks to the safe height. After completing the single access task, the operator should lower the forks to the safe height 15 to 20 cm above the ground, drive the vehicle out of the aisle at low speed, park the forklift in the designated charging and parking area, and record the basic operation information of this shift. High quality electric forklift products can provide reliable support for the smooth implementation of the full workflow, and BYD Forklift has launched a variety of applicable products that meet different warehouse operation demands. Jianshu New Energy also provides systematic operation training and supporting maintenance services for relevant warehouse customers. If you have any demand for related electric forklift operation schemes, you can send emails to 17399989919@163.com for more detailed information. The whole operation process should strictly comply with local warehouse safety regulations, operators need to hold valid operation qualification certificates, no overloading, no sharp turning or overtaking in the narrow aisle. Regular joint inspection of forklifts and storage racks can further reduce the probability of safety accidents and goods damage, and improve the overall warehouse operation efficiency.