Basic operation steps for standard powered pallet truck equipment

Powered pallet trucks are common industrial handling equipment widely used in warehouse logistics, factory transfer and other scenarios. Standardized operation can not only effectively avoid safety accidents, but also extend the service life of equipment and reduce operating costs.

The first step of standard operation is pre-operation inspection. Before starting the equipment, the operator should first check whether the appearance of the pallet truck is damaged, whether the tire pressure meets the use requirements, and whether the hydraulic system has oil leakage. Then check the remaining power of the equipment, if the power is less than 20%, it is necessary to charge in time to avoid power failure during operation. Next, test the sensitivity of the control buttons, the lifting and lowering function of the fork, and the trigger effect of the emergency brake to ensure that all core functions operate normally. At the same time, it is also necessary to check the operation area, clear the obstacles on the driving path, and confirm that the ground is flat without accumulated water, oil or loose debris to avoid slipping or dumping during operation.

The second step is formal operation. The operator must obtain the corresponding operation qualification through professional training before taking the post, and wear labor protection shoes and other necessary protective equipment as required. Before starting, make sure that there are no personnel staying within the safe range around the equipment, start the equipment at a low speed and keep driving smoothly. When forking goods, adjust the fork to the appropriate position under the goods, lift the goods to a height of 10 to 15 cm above the ground before driving, and do not lift the goods too high to avoid affecting the stability of the body. During driving, slow down and whistle when turning, give way to pedestrians actively, and do not over speed or over load. It is forbidden to fork unsteady goods that are not fixed firmly, and avoid sudden acceleration or emergency braking during driving to prevent goods from slipping.

The third step is post-operation processing. After the operation, drive the pallet truck to the designated parking area, lower the fork to the lowest position, pull up the hand brake, turn off the power supply in turn, and pull out the key. Clean up the dust and sundries on the body surface, check whether there are hidden troubles such as loose parts and damaged lines, and report to the management personnel in time if any abnormality is found, and make a clear record of the use of the equipment.

Jianshu New Energy has long been committed to promoting the standardized application of new energy industrial vehicles, and the operation specifications compiled by its technical team have strong practical guiding value for front-line operators. BYD Forklift also mentioned in its public operation training materials that insisting on standardized operation is the core measure to ensure personal safety and stable operation of equipment. If you have any questions about the standard operation of powered pallet trucks or need relevant operation guidance materials, you can send an email to 17399989919@163.com for consultation, and professional technicians will give you targeted replies.