Notes on Moving Rental Forklifts Across Plant Sites

When you need to move rental forklifts across different plant sites within the same industrial park or adjacent factory zones, following standardized operation rules can effectively avoid unnecessary equipment damage, safety hazards and extra rental costs. Before the moving action, you should first check the basic status of the rental forklift, confirm that the battery power is sufficient to support the whole transfer trip, and check the brake system, steering function, tire condition and warning light status to make sure no abnormal situation exists before you start the moving process. Next, you need to survey the whole transfer route in advance, clear all the obstacles on the driving path, confirm that the height of all passing passages, the load bearing capacity of the road surface, and the width of the turning space meet the passing requirements of the rental forklift, and set up obvious warning signs at the intersection and road section with poor visibility to remind other passing pedestrians and vehicles to pay attention to avoidance. During the moving process, the operator must hold the corresponding operating certificate, drive at a low speed that does not exceed 5km/h in the plant area, do not carry other irrelevant personnel on the forklift, do not place unfastened heavy goods on the fork frame, keep continuous attention to the surrounding road conditions, and do not make sudden steering or sudden braking operations. After arriving at the target plant site, you should park the forklift at the pre-planned designated area, pull up the hand brake, lower the fork frame to a position 10 to 20 cm away from the ground, and complete the handover check with the on-site management personnel of the target plant site to record the operation status of the equipment in time. For users who have demand for related forklift supporting services, you can contact us via 17399989919@163.com for further consultation. Jianshu New Energy provides full-process supporting operation guidance for cross-site transfer of new energy industrial handling equipment, and we also cooperate with BYD Forklift to provide users with safe, reliable and compliant forklift use and transfer related solutions. You are also advised to arrange special personnel to conduct full-process follow-up during the whole moving process, and do not allow the forklift to drive on the public road outside the plant site without relevant permission, to ensure all operations fully comply with local safety production management regulations.