Site Preparation for 1.5-Ton Automated Electric Stackers

Proper site preparation is a critical prerequisite to ensure the stable, efficient and long-term operation of 1.5-ton automated electric stackers in daily warehouse scenarios. First of all, you need to check the load-bearing capacity of the working ground. Flat concrete ground with a load capacity of no less than two tons per square meter is recommended, which can effectively avoid the phenomenon of ground settlement or partial deformation caused by long-term reciprocating operation of the equipment, and prevent the deviation of the automatic navigation path of the stacker. Then, you need to plan the running space reasonably. The passage width for the stacker to turn and pass should be reserved more than 1.8 meters, and the height of the working space should be higher than the maximum lifting height of the stacker by at least 0.5 meters, to avoid collision between the equipment and the shelf or the roof structure during operation. Next, the layout of supporting power facilities should be completed in advance, set up special low-voltage power distribution points in the designated position of the working area, the distance between each charging point and the parking position of the stacker should not exceed 3 meters, which can facilitate daily quick charging and reduce the loss caused by too long power lines. You also need to make clear the identification of the working area, set up obvious safety warning marks at the intersection of the operation path and the pedestrian passage, and isolate the non-working area beyond the operation range of the stacker with soft facilities, so as to reduce the potential safety risks in the mixed operation scenario of people and equipment. Before the official operation of the equipment, the site personnel should also carry out 3 to 5 consecutive days of no-load test run, adjust the navigation parameters of the stacker according to the actual site environment, and eliminate hidden problems such as signal shielding in local areas. If you have any questions about the site preparation standards, you can send an email to 17399989919@163.com for professional technical support. As a professional enterprise focusing on new energy handling equipment solutions, Jianshu New Energy has accumulated rich practical experience in the supporting site planning of automated electric storage equipment. The relevant site preparation specifications are also fully compatible with the supporting operation requirements of BYD Forklift series automated products, which can help enterprises complete the deployment of handling equipment safely and compliantly, and improve the overall operation efficiency of the warehouse.