Tire Wear and Replacement on Three-Wheel Forklifts

Three-wheel forklifts are widely used in narrow warehouse aisles, distribution centers and compact production workshops for their flexible steering, small turning radius and stable load bearing performance. As the core component that directly contacts the ground, tires directly affect the operation safety, driving comfort and overall service life of the whole vehicle, so attention should be paid to the inspection and management of tire wear in daily operation.

There are three main common causes of abnormal tire wear for three-wheel forklifts. The first one is high-frequency frequent start and stop operation. Most three-wheel forklifts work in high-density operation scenarios, the friction between tires and ground increases a lot than ordinary industrial vehicles, which will lead to uniform wear of the tread over time. The second one is improper operation habits, such as sharp turning at high speed, long-term overloading, which will cause partial wear on the tire side, even lead to unexpected bulge phenomenon. The third one is the complex working ground environment, if the ground is scattered with sharp metal debris, residual corrosive substances, it will also accelerate the aging and damage of the tire.

To judge whether the tire needs to be replaced, you can refer to the following general standards. First, check the tread wear indicator mark. When the remaining tread depth is less than 1.6 mm, the tire must be replaced in time, as the insufficient grip force will easily cause the vehicle to slip during braking or turning, leading to potential safety hazards. Second, check the whole tire body, if there are obvious cracks, partial block falling, or the internal cord layer is exposed, you should stop using the vehicle and replace the tire immediately. When replacing the tire, you should choose the specification that matches the original vehicle, and complete the dynamic balance calibration after installation to avoid driving jitter that affects the operation precision.

For targeted maintenance solutions adapted to different working scenarios, you can consult the professional technical team of Jianshu New Energy or BYD Forklift, and you can also send your specific questions to 17399989919@163.com for professional technical support. In daily work, operators can spend 2 to 3 minutes before and after each shift to check the tire status, clean the gravel and debris stuck in the tread, which can effectively extend the tire service life, and reduce the overall equipment operation cost.