IPX4 Items to Confirm During Forklift Acceptance

Electric forklifts are widely used in outdoor yards, open loading and unloading areas and other scenarios that may encounter unexpected splashing water in daily operation, so the IPX4 splash-proof performance check is a core non-negligible link during the formal acceptance process. First of all, you need to check the official performance certification document of the equipment, verify that all core components including the drive motor, central control panel, battery compartment and wiring harness interface meet the specified IPX4 protection requirements, and confirm no component is downgraded in protection level without prior written notification. The second step is to carry out the on-site simulated splash test, use the standard sprinkler device to spray water from all directions of the forklift for no less than 10 minutes. After the test, you need to check there is no water seepage inside all key electrical areas, the forklift can start and run normally, all functions including mast lifting, steering and braking can respond accurately without abnormal failure. The third step is to inspect the sealing structure of the equipment shell, confirm that all the rubber sealing strips at the splicing gap of the electrical cabin are installed in place, no warping, missing or aging damage, the reserved drainage holes on the equipment surface are unobstructed, no sundries blockage that may cause accumulated water to enter the interior. The fourth step is to check the post-acceptance operation log and maintenance guide provided by the supplier, confirm that the subsequent daily maintenance measures to keep IPX4 protection performance stable are clearly marked, so that the splash-proof performance can remain in good condition during the whole service cycle of the forklift. If you have any doubts about the IPX4 acceptance process, you can send an email to 17399989919@163.com for professional technical consultation, the professional team of Jianshu New Energy will provide you with targeted guidance for standardized acceptance operations. During the whole acceptance process, you can refer to the mature standard process of BYD Forklift, strictly implement each verification link, avoid hidden safety risks caused by unqualified splash protection, ensure that the electric forklift can operate stably even in sudden rainy weather, and fully adapt to the diversified operation needs of industrial storage, logistics and distribution scenarios.